PEX 0: Root Complex Interface, Detected Link X1, GEN 2.0 High speed PHY - Version: 2.1.4 (COM-PHY-V20)ĭDR3 Training Sequence - Run without PBS.ĭDR3 Training Sequence - Ended SuccessfullyīootROM: Image checksum verification PASSED Plugged the USB-stick into the ReadyNAS RN102, connected power, hit the power button, interrupted u-boot, did 'printenv' and then 'boot'. 19 2019 zImage-5.2.9-mvebu-tld-1*ĮDIT: These commands should be added to avoid the "Cannot read bad block mark: Invalid argument" issue below. Image Type: ARM Linux Kernel Image (uncompressed)ĭata Size: 4076820 Bytes = 3981.27 KiB = 3.89 MiBĭrwxr-xr-x 3 root root 4096 aug. Image Name: Linux-4.20.6-mvebu-mirabox-tld-1 Tar xf /tmp/bodhi/linux-4.20.2ĭrwxr-xr-x 2 root root 4096 aug. Mkdir usr/src/mirabox & cd usr/src/mirabox 2 2017 srv/ĭrwxrwxrwt 2 root root 4096 sep. 9 2017 lost+found/ĭrwxr-xr-x 2 root root 4096 jan. Tar xf /tmp/bodhi/Debian-5.2.2ĭrwxrwxrwx 21 root root 4096 jan. Mounted the USB stick on /mnt and, following your instructions, extracted the input files onto it: Made a screenshot (attached) and closed 'gparted'. Selected the newly added device in the upper right pull-down menu, created a 'msdos' partition table and formatted the USB-stick with a single partition labeled 'rootfs' containing an 'ext3' file system, and applied the pending operations. Plugged in the USB-stick and did Refresh Devices. On my Ubuntu 20.04 laptop, I downloaded the input files to /tmp/bodhi. Complete procedure follows mainly for my own later reference. Following Netgear's example, including the last, say, 4 characters in the hostname is one possibility.įollowing up this post, I have performed a fresh install of your latest Debian version, but with Linux kernel 4.20.6 and the modified device tree for the ReadyNAS RN102. My serial number is a sting of 13 characters consisting of digits and upper case letters only. I like the idea of giving each unit a (more or less) unique 'hostname', but I think using a part of the u-boot environment variable 'SerialNum' would be a better solution than using a part of the mach address. TX packets:0 errors:0 dropped:0 overruns:0 carrier:0Īs well as for setting the default 'hostname': RX packets:0 errors:0 dropped:0 overruns:0 frame:0 I notice that the stock kernel uses the u-boot environment variable 'eth1addr' for setting the mac address:Įth0 Link encap:Ethernet HWaddr 12:34:56:78:90:ab Later I will be able to compare Debian against Debian. I will keep the vendor's firmware on the second one for some time to be able to compare Debian against stock. I have two RN102 units now and can thus test alternative solutions against each other for performance or other behavior.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |